Engine bay
-
Check there is sufficient free play in
all electrical wiring
-
Check there is sufficient free play
in pipes to brake master cylinder and clutch master cylinder and
cover to ensure debris remains out of pipes.
-
heck there is sufficient free play in
heater hoses
-
Disconnect throttle cable
Chassis fixing bolts
-
remove seats - replace original bolts
with stainless steel ones with allen key heads
-
remove carpets or pull back from
chassis bolt areas
-
remove seat belts & anchor points (3
off each side)
-
remove other fixing, 4 off in front
footwells, 2 off middle mounts either side of tunnel, 2 off below
seat belt unit, 2 off in boot. 2 off bolts under centre console (by
radio).
-
remove handbrake lever and
disconnect cable
-
disconnect speedo and reversing light
electrics from gearbox
Petrol tank
-
clear away sealant around petrol tank
neck and bodywork in the boot
-
remove filler pipe at both top and
bottom flexibles.
-
disconnect electrics from fuel pump
and fuel level sender
Gear Lever
-
remove 2 off self tappers from each
side rear of centre console and lift rear
-
remove gear lever rubber gaiter
-
I removed central console to gain
access to 2 bolts under the central control panel.
Steering removal
-
Undo top universal joint on steering
colum
-
Loosen steering rack securing bolts
to give enough movement (other option is to
loosen off steering column and pull from inside car).
-
Pull steering rack forward until UJ
splits apart.
Final checks
Photos
Home Page |
|